Question.

[Master]

Does any one of you know if there is a possibility for this Predator ( http://www.sideshowtoy.com/?page_id=4489&sku=900141 ) to be produced in 7 or 8 inch scale?

I like it allot but it eventually won`t fit rest of my collection.

[MIMIC]

I only buy 7 and 8 inch models (except for queens) so I wouldn't know.

[Master]

Fast reply! Thanks

[Uncanny Antman]

Answer: No, probably not.

[FACEBOX]

A: I don't think so

[Master]

Damn... Maybe a petition then??

[Xenomrph]

Like, one of those online petitions? Won't do any good.

[Master Chief]

Looks like you're going to have to get creative on this one.  Customize one of your MM6 Predator figures to match. Take the head off your "Predator The Hunter" and put it on your Predator 2 figure.  Paint it to match the Hot Toys figure.  It'll be close.

[Uncanny Antman]

^You'd need to do a fair bit of scratch-built armor though.  Gauntlets, chest, and that thigh piece that looks a lot like it came off of Robo or 3PO.

[Master Chief]

Yeah, I was trying to figure out what action figures he could use for the body armor.  The only ones that I can think of are the McFarlane Spartan figures.  Some of their chest plates and arm armor resemble the "lost hunter's".  But I know he wouldn't dare tear apart a Spartan.

[ArielAleXCo]

i know... its simple.... get the image in HD.

reduce it to 8 inch, width 300ppi, ... then go to youre favorite print store... give them the file, print it, cut it... and you are all set.   

and its made on 8 or 7 inches, your choise.



wont be 3D... but youll have the size

[Master]

Like, one of those online petitions? Won't do any good.

I was kidding 

know... its simple.... get the image in HD.

reduce it to 8 inch, width 300ppi, ... then go to youre favorite print store... give them the file, print it, cut it... and you are all set.   

and its made on 8 or 7 inches, your choise.



wont be 3D... but youll have the size

That won`t do any good either cause I want model not image in proper size.