I'm not entirely sure what the tool I used was to do most of the work, but it basically looks like a screwdriver but the head it cone shaped. (Looks like a bit sewing needle on a screw driver handle.) I also used an exacto knife in some spots.
There should be a small openning on both sides of the aliens dones, above the ridges. The dome is made of soft plastic so what you wanna do is GENTLY used the needle tool to lift the dome outward, breaking the glue near it, and make your way toward the face. There are 2 tabs about where the teeth are. They should come undone if you keep using the needle tool.
When you've loosed the from of the dome and go to the back, that's were the exacto knife comes in. You need to use it to dig under the dome. Be VERY careful and break the seal. The Very back of the dome, I'm not entirely sure but I couldn't get it off, and didn't want to cut it off. I'm guessing its a larger tab. But you won't need to completely remove the tab. You should be able to open the dome. Then use either Silver or White modeling paint (I used Silver) to paint the inside of the dome. Paint all of it and evenly. Don't worry about the black painted sections because those are painting on the OUTSIDE of the dome, so the hard part has been done for you.
After that, put the dome back down and secure it with glue. (At least in the tabs. the dome holds pretty well without it as long as you didnt sever the back.) Congradulations, you have a more screen accurate Giger Alien.
Quote from: ScarPredator14 on Apr 17, 2011, 03:53:25 PM
Yea I have scar and Celtic but I don't wanna ruin them lol and I know the predator had the same kinda packs I just used the exta wolf pack I had to make it so yea the fig is not complete accurate I just used whatever I had
You want one of mine? I don't have any use for them other than decore.